Monday, June 22, 2009

Tuesday, June 16, 2009

Preventing Over Dispense Using a Robot and High Pressure Valve

Using the 790HP valve
Case history of an I&J Fisnar system comprising an Extruder Pump, a material flow regulator, and and I&J Fisnar Inc 790 HP valve to dispense a line of silicone with a robot.

At the start of the line there was an extra quantity of silicone dispensed, which was not acceptable.The first reaction was that it was simply a problem in programming the robot, but :

1) The programmer started to move and dispense without delay : no effect

2) The programmer started to move with dispense off then at a passing point I opened the valve : it reduced but still there was an extra quantity at the beginning of the line.3) It was apparant that this “extra material “ come from the diameter of the piston of the 790 HP which tended to force the extra material when the valve is opened.

The solution is to program as 2) but also to reduce the pressure on the dispenser and to open the valve slowly.

The result – perfect.

In this application a good pressure is 4,2 bars, but it could be different depending on the spring of the valve and the pressure of the material.

The way to find the correct pressure is to gradually reduce until the valve doesn't open then slowly increase until it does.

www.ijfisnar.com

Friday, June 12, 2009

Consumable Kit Box



A rugged kit box containing most popular sizes of dispensing tips with standard and UV barrels including pistons. This is not a presentation box but a rugged (drop on the floor - won't break open) working box with most of our most popular consumables.

For details contact info@ijfisnar.com

View are web site at www.ijfisnar.com

Thursday, June 11, 2009

Spray Valve Controller - Advice Sought

The question is how to operate the controller different. I mean to open the valve first, after the pre-shot time start to spray air and before ending the cycle first stop the spray air and a certain time later close the valve. It’s just the opposite to the drawing below.


Looking for your recommendations, best regards

DOTEST, S.L.
Jordi Vacarisas
Tel: +34 93.4905560
Web: http://www.dotestsl.com/

For information on I&J Fisnar dispensing products go to: http://www.ijfisnar.com/

Wednesday, June 10, 2009

New Meter Mix Press Release June 10th 2009

Press Release
June 10, 2009
Meter Mix made
EASY with I&J Fisnar Inc


Meter Mix Dispensing of Dual Component Fluids

I&J Fisnar Inc removes the mystery of metering and mixing and helps to step through the process of selecting a Meter Mix solution. Our systems are designed for continuous operation and with the IJF guarantee of service you’re in good hands.

From micro shots to high volume applications, whether potting, bead laying, form-in-place or filling with any adhesive, polyurethane, resin or epoxy, we will configure a system uniquely tailored for any ratio or fluid combination at an affordable price.

Our Meter Mix units can be simply interfaced to inline and table top robotics and our highly trained project engineers are experienced in recommending the right automation solution that is cost effective and simple to install.

Stand-alone or automated integration - I&J Fisnar Inc provides the right Meter Mix solution

Visit our website today and chat with a member of our friendly Customer Care or Technical Engineering Team

Contact:
http://www.ijfisnar.com/
201-796-1477

Announcement - Meter Mix

In case we didn't get everyboody in our email broadcast last week - our new and exciting range of I&J Fisnar Meter & Mixing equipment is available on our web site and the questionnaire has been amended to make the process easier to complete.

We would welcome any Meter Mix questions you wish to share as comments to this posting.

Link to: http://www.ijfisnar.com/metermix_index.cfm